• Positioning of the Back Heat Transfer Decal Back designs should be positioned utilizing the center crease and four inches down from the middle of the neckline to ensure a professional appearance. There are a number of quite handy websites available that provide even more exact shirt decal placing instructions.

Where to place a decal on the back of a shirt?

Back designs should be positioned utilizing the center crease and four inches down from the middle of the neckline to ensure a professional appearance.

What size should a decal be on the back of a shirt?

For the most part, adult-sized shirt designs should measure between 11 and 14 inches in length. For children’s shirts, you just need between 5.5 and 9 inches in length. Although the design size might vary based on what you’re doing, these are decent starting points.

How far down do you place a decal on the front of a shirt?

First, take a measurement 2″ – 3″ down from the middle of the neckline on the front. Depending on the size of the garment, this is the point at which the top of your design should fall. Measuring 2″ down for smaller sizes and 3″ down for bigger sizes is the rule of thumb.

Where should a logo go on a shirt?

Since the majority of logos are placed on the left chest of the person, a name or a name patch might be placed on the right side of the people chest. A vertical center line is drawn on the inner edge of the collar to help with alignment of the logo or design on the shirt. The bottom of the logo is usually no lower than the bottom of the placket of the polo shirt, unless otherwise specified.

Which side goes down on an iron on vinyl?

When you’re cutting, the shiny side is on the bottom. The vinyl side should be facing up. Cut through the vinyl but not through the carrier sheet if you want to get the best results.

Where do you put a transfer on a shirt?

CHEST, LEFT AND RIGHT The vertical line will begin slightly off the side of the collar and run straight up. The horizontal line will begin at the seam between the armpits. The design should be put at the point where these two lines come together. IMPORTANT: Avoid placing the pattern too much to the left (or right) of the body since it may end up in the armpit region.